User's Manual

10
Loose knob “T” until 28 mm (1 1/8”) luminair
spigot can be fully inserted into the clamp. Insert
the 28 mm (1 1/8”) luminair spigot on the
female attachment “R” until it protrudes as
shown in figure 12.
The spigot has an hole drilled through it, into
which you should insert the safety pin “U” in
such a way that it protrudes equally from both
sides of the 28 mm (1 1/8”) spigot.
Now lift the clamp so that the safety pin ”U”
seats captive in the recessed depression “Y”
and temporarily holds the weight of the luminair.
Then tighten the locking lever “T” firmly against
the recessed safety grove on the spigot.
BOTTOM ATTACHMENT
12
BOTTOM ATTACHMENT
13
28MM - (1-1/8”) FEMALE ATTACHMENT
Unscrew knob “Z”, depress button “B”, insert
the male attachment “X” on the hole “Y” and
release the button. Lock firmly knob “Z”: ensure
that the knob is able to seat in the recessed
safety groove on the male attachment (fig. 13)
Button “B” serves as safety catch, but it is
strongly recommend to secure the load with
appropriate safety cable (not supplied).
To dismount the load proceed as follow:
HOLDING the load with one hand, unlock the
knob “Z” and then depress button “B”.
16MM - (5/8”) FEMALE ATTACHMENT
T
T
Y
U
U
R
1
2
3
1
2
Z
Y
X
B
12
13