User's Manual
PANTOGRAPH TOP 4C FF3514N86
The pantograph is made of aluminium (P-Al MgSi UNI 3569) and manufactured according to DIN 15560-46. The attachments at both ends of the pantograph are
16mm, male on the bottom and female on the top. The load is supported by a steel cable of 2mm. diameter (safety factor 12). Loads up to 12kg can be suspended
using only the patented friction device, while loads up to a maximum of 18kg require the use of the optional springs. The pantograph can be regulated to keep su-
spended loads from 1 to 18kg perfectly balanced. By turning the coulored notched ring you can adjust the pantograph’s friction; this will ensure that the load remains
stable when set in position, but that it will move smoothly up and down when necessary. In any case, it is always advisable to use the springs to aid raising your
pantograph. When choosing the additional spring(s) for your pantograph, you will rst need to know exactly which model of pantograph you have, in order that you
can select the spring of the correct length. If you have one of the new compact pantographs (with grey-painted “scissors”), look at the colour of notched ring the 2m
version has a red notched ring, while the 3.8m version has a blue notched ring. After having identied the length of the pantograph, choose the appropriate spring(s)
by refering to the table below.
PANTHOGRAPHS SKY TRACK SYSTEM
Width
Max extension Closed lenght
Model FF3514N86
Lifting rope 2mm wire rope
Safety factor rope 12
Self weight 7.3kg
Max working load 18kg
Closed length 38cm
Max extension 380cm
Width 15cm
Both sides have 16mm spigot. Used to connect two units with 16mm female
attachment or to obtain 16mm spigot from a 16mm female attachment.
SPIGOT ADAPTER 013
Both sides have a 16mm attachment. Used to connect two units with 16mm
spigot, or to obtain a 16mm female attachment from 16mm spigot.
16MM FEMALE ADAPTER 158
4 sections, 3 risers. Ø: 28, 24, 20, 16mm.
Minimum extension: 160cm. Maximum extension: 400cm.
Closed length: 142cm.
OPERATING POLE 427B-4.0
4 sections, 3 risers. Ø: 28, 24, 20, 16mm.
Minimum extension: 220cm. Maximum extension: 650cm.
Closed length: 200cm.
OPERATING POLE 427B-6.5 Not illustrated
These are inserted from the end of the rail. They do not need wheels as they they
slide along the rail and are suitable for normal cables.
KIT OF 5 CABLE CARRIAGES FF3226
These are from the end of the rail and run on ball-bearings. They are suitable for
heavy cables.
KIT OF 5 CABLE CARRIAGES WITH BEARING FF3226C
ACCESSORIES AND ADAPTERS SKY TRACK SYSTEM
These t to the holes on the ends of a rail to prevent carriages leaving the rail and
to prevent moving rails leaving their carriages.
IMPORTANT: must be tted to upper and lower holes on moving rails but only to
lower holes on xed rails.
KIT OF 4 END STOPS WITH 4 CABLE CARRIAGES FF3207
A pair of clamp plates with screws to join two xed rails together by clamping
across the junction on the upper guide, using holes provided in the rail.
IMPORTANT: the junction must always be supported by a rail-mounting bracket
placed astride
ALIGNING CONNECTORS FOR FIXED RAILS FF3208
101100