User's Manual
RAILS ATTACHMENTS SKY TRACK SYSTEM
Used alone or in combinated these brakets allow the attachment of the rails at the
desidered height.
CEILING BRACKET WITH 50CM EXTENSION FF3218
Its length is adjustable from 10cm to 15.5cm. Using the clamp screw, you can
obtain all intermediate sizes. Provided with a security lock, in case the regulating
screw loosens, blocks the bracket at maximum extension. It’s used to compensate
for height dierences in ceilings of 5.5cm or more, with combinations of other
brackets. It’s also used for obtaining intermediate sizes in combination with the
extendable ceiling brackets.
EXTENSION BRACKET FOR VARIOUS HEIGHTS FF3215A
BRACKET FOR TUBE ATTACHMENT FF3214
This can be fastened to tubes with diameters from 35mm to 50mm inclusive. It’s used
to directly support the rail that can be xed in place either longitudinally or transversely.
This bracket can be used as a brace for xed supports, as well.
CEILING BRACKET WITH
100CM EXTENSION FF3220 Not illustrated
RAILS ATTACHMENTS SKY TRACK SYSTEM
This carriage can be inserted directly at any point on the rail by unscrewing
the wheel plate. This is used when it becomes necessary to add a
supplementary carriage to an already assembled RAIL SYSTEM installation. It is
free-sliding and is suitable for normal loads.
DISMOUNTABLE SLIDING CARRIAGE
WITH 4 WHEELS AND 16MM SPIGOT FF3228
Can be attached directly by screws or rods with a maximum diameter of 1/2”.
Before mounting the bracket it is advisable to standardize the length of both the
rods and screws. Fix the bracket between a nut allowing the screw on the inside of
the bracket to protrude about 1.5cm. When xture is completed, it is then possible
to regulate a perfect rail levelness by adjusting the nuts which fasten the brackets.
BRACKET FOR CEILING ATTACHMENT FF3214A
It is free-sliding carriage.
It is suitable for normal weight loads up to 60kg.
SLIDING CARRIAGE WITH
4 WHEELS AND 16MM SPIGOT FF3230
Comprised of a bracket to be attached to the ceiling with 4 screws, a 1m long
M12 rod completely threaded, 4 M12 nuts, and a bracket for the rail xture. The
rod can be cut to the desidered size and then attached to the bracket by way of
the nuts supplied. The rod must protrude approx 1cm on the inside of the bracket.
When xture is completed, it is then possible to regulate a perfect rail levelness by
adjusting the nuts which fasten the brackets.
RAIL MOUNTING KIT WITH M12 STUD FF3214B
This is provided with a brake which keeps it locked in the position where it is placed.
It is suitable for normal loads up to 60kg.
To release brake pull down on wire with operating pole.
SLIDING CARRIAGE WITH 4 WHEELS,
BRAKE AND 16MM SPIGOT FF3229
Both the upper carriage and the lower one are free-sliding.
DOUBLE SLIDING CARRIAGE FF3232
This is equipped with brakes on both upper and lower carriages.
The upper brake blocks the carriage on the xed rail,
while the lower carriage’s brake blocks the sliding of the moving rail.
DOUBLE SLIDING CARRIAGE
WITH DOUBLE BRAKE FF3235
The 16mm spigot allow the mounting of lights or accessories with 16mm female
attachment.
FIXED BRACKET ON RAIL WITH 16MM SPIGOT FF3856
This is provided with a brake on only one carriage. Normally, the carriage with
brake is mounted on the xed rail so that it is locked into place enabling the mobile
rail to slide. If the carriage with brake is mounted onto the mobile rail, you obtain
the opposite eect, that is, the sliding of the mobile rail gets blocked, while the
carriage can freely slide on the xed rail.
DOUBLE SLIDING CARRIAGE WITH ONE BRAKE FF3236
9998