Manual

LUBRICATION
Use proper lubricants.
[CO__MP_ONENT!LUBRICANT
RollerChains / Spray-on graphite based chain lubricant
I_ Bearing/ Automotive SAE 30 weight
INSPECTION
2.
,
1. It may be necessary to remove guards covering
drive components. 4.
2. Apply proper type spray-on chain lubricant
thoroughly inside and outside plates and rollers of
chain, Move Fun-Kart as needed to access entire 5.
chain.
3, Replace guards covering drive components.
Install new guards if damaged,
Remove guards covering drive components.
Install new guards if damaged.
At the center point between the two sprockets,
push and pull the chain and note total flex. If flex
is more than 1/2", adjust chain. Refer to
ADJUSTMENT.
Inspect chain sprockets for wear.
If sprockets are worn, replace sprockets and
chain(s). Sprockets and chains must be replaced
as a set.
Replace guards covering drive components.
Install new guards if damaged.
3/8" FLEX
AVERAGE
©
MK007
Figure 8. Chain Lubrication and Inspection
28