User Manual

1.4
If you want to use an existing motor mount, you need to drill a
1.7 mm hole at a distance of 17mm away from the motor shaft.
You can now attach the pitch lever to the motor mount.
1.4
M2x4mm
M1,5x6mm
1,5x4mm
17mm
1,7mm
1.5
The variable pitch prop unit is fastened to the motor shaft with one setscrew. The aluminum prop
adapter needs to be positioned all the way towards the ball bearing of the motor (to prevent the motor
shaft from moving during negative pitch phases).
Loosen the attachment screw of the pitch lever; ensure that the small ball bearing runs between the
two discs plates, and tighten the screw again.
1.5
M3x3
1.5
1.6 Connect the pitch lever with the pitch servo using a rod with a Z-bend. For best performance
and to avoid oscillations, try to keep the connecting rod as short as possible.