User Manual

- 30 -
and print speeds. Fine turning these for specific STL files, can produce
cleaner prints.
Pause at Z height
Pause your print at a specified height. You can also specify where to move
the print head and how much filament to retract. This will prevent “lobs”
from accumulating on your print while paused. This setting is most
commonly used when switching colors of filaments in the middle of a print.
1.11 Start and End G Code Settings
Custom G Code allows for complex automatic printer movements and
operations. By adding custom G Code into the start or end of your file, you
can alter how it prints. A comprehensive list of G Code commands can be
found here: http://reprap.org/wiki/G-code.
1.12 Expert Settings
Expert settings will give you more specific options for your retraction, skirt,
active cooling, infill, supports, brim, raft, and special settings. To gain access
to this section you go to Expert＞Open Full Settings or on your keyboard
press Control+E.