User Manual

- 26 -
Platform Adhesion Type
Some models have a small surface area contacting the plate. This can create
adhesion issues causing your part to pop off at some point during the print.
To fix this, use either Brim or Raft. Raft is better used when a model has
small heated bed contact points and overhangs.
Brim
Brim will created a single layer of filament, contracting and surrounding
your model. This will increase the surface area of the part contacting the
build platform thereby preventing it from popping off the heated bed. Brim
will also help in situations where you are seeing corner lift. Brim settings can
be adjusted in the Expert Settings options.
Raft
Raft will generate a layer of material underneath your object. Raft was more
often used before the addition of heated plates to increase surface area.
Raft settings can be adjusted in the Expert Settings options.
Filament Diameter
The filament diameter setting is one of the more important settings. Make
sure that you update this value periodically with your average filament
diameter. While your filament may be referred to as 3mm, it is more likely