User Manual

- 25 -
Your overall printing speed can be adjusted here. If no other speeds are
determined in the later sections your printer will automatically default to
this speed. This speed will be different, depending on what type of filament
your are using.
Printing Temperature
When using different filament materials you'll need to update the desired
hot end and heated bed temperature. Any temperatures specified here will
be used to automatically set both the hot end and heated bed. Your print
will not begin until these temperatures are met. The 3D printer needs to
have the temperature specified in order to run through the automatic bed-
leveling routine.
Support Type
Some models will require support material in order to print properly. This
will usually occur when an object has an angle in relation to the build plate
between 0 to 45 degrees. It is highly recommended to orientate your object
so that it minimizes or eliminates the need for support.
Touching Build plate
This causes the support material to build up between the heated bed and
the object. The red example is "Touching Build" plate.
Everywhere
This prints support material between the heated bed and object as well as
between the object and itself. The green example is "Support Everywhere".