User Manual

- 2 -
A. PRECAUTIONS
1. Do not strip the yellow paper on the glass sheet, it is for anti-slip
printing.
2. Do not strip the wrapper which wraps up the nozzles, it is for holding
the nozzle temperature.
3. Use this printer under the right power and follow all local laws.
4. Be aware of hot heat blocks, nozzles, extruded filament and heating
plate.
5. Do not wear gloves when operating or repairing to avoid
entanglement.
6. Do not leave the machine unattended when it is in operation.
7. Do not throw, disassemble, crush, burn your 3D printer or load
unsupported filament.
8. Keep your 3D printer and all accessories out of children's reach.
9. When printing via USB, keep a stable connection between the PC and
the printer.
10. Do not move the dual extruder during printing.
11. Do not pull or twist the black cable any time.
12. Do not force or tear anything during unpacking and setup. This may
damage the printer.
13. WARNING
a) Never reach inside while it is in operation. Always allow it to cool
down before reaching inside.
b) If opening the printer for service, ensure that the power supply is
turned off and the cord is disconnected.
14. CAUTION
a) The printer was built and packaged very carefully at the factory. We
hope you will take your time and be just as careful unpacking it
and getting it set up.