Tus neeg siv phau ntawv

Table Of Contents

2.3 - MOBILE APPLICATION USAGE

2.3.1 – CONFIGURING MALMBERGS EV MOBILE APPLICATION

In standalone usage mode, the master RFID card is already registered to your charger. If you tap

the master RFID card to your charging station when the charging cable is not connected, your

charger starts broadcasting over Bluetooth and indication LED starts to blink blue for 60 seconds.

You can configure Malmbergs EV Mobile Application from your smartphone in this period of time.

If you do not make any configuration in 60 seconds, charging station exits from configuration mode

and returns to its previous mode.

2.3.2 - MALMBERGS EV MOBILE APPLICATION CONFIGURATION:

It is required to starts configuration from your smartphone within 60 seconds after the configuration

mode starts. If you do not make any configuration in 60 seconds, Bluetooth broadcasting finishes

and configuration mode ends.

Please download Malmbergs EV Mobile Application from Android Play Store or IOS App Store.

You can reach to the application by QR code below.

Open Malmbergs EV Mobile Application. To configure your charger, select EVC04 model shown in

picture above and click continue button and follow the instructions which are mentioned inside

the application in detail to setup the charger and finish the configuration. Please note that after

first configuration your EV charger and Mobile Application connect locally via Bluetooth, so you

can only monitor and control your charging session when you are near the charging station. If you

want to monitor and control your charging station from the Internet remotely, you need to config-

ure Internet connection settings of your EV charger from “Connectivity” tab in “Device Settings”

menu. You can either use Ethernet LAN connectivity or WiFi WLAN connectivity option.