Specifications

Fire Drum 2

Continued

1. Open the top of the larger carton. Remove the corner packing supports. Lift out the top

metal hood and then lift out the top refractory casting. Be careful not to drop this refractory

piece. Remove the center packing pad. It is not necessary to remove the bottom refrac-

tory casting from the fire-bowl assembly, this should remain in place in the bottom fire-bowl

assembly.

2. Lift out the bottom fire-bowl assembly or slit open one side of the carton for access to the

assembly.

NOTE: Due to the weight of the fully assembled fireplace unit it would be advisable to tempo-

rarily position the bottom fire-bowl assembly in the desired location for installation. The

metal hood may be set on the base assembly without the top refractory casting or side wall

refractory bricks in order to determine the chimney location. The floor protection (hearth

extension) size and location should be determined at this time also. Refer to installation

Instructions.

The base assembly should now be removed and the chimney and hearth extension in-

stalled. The fireplace assembly can then be continued and completed after the chimney

and hearth extension are installed.

3. Open the smaller carton now and remove the corner packing supports, the screen box,

Page - 2

Side Wall Refractory

Bricks 1 Thru 4

Cap Screw

Spacer Bolt head

to inside

Optional

Baffle

Opening Fin

Illustration No. 2

Make Certain Fiberglass Strip Seal

Begins At This Point And Ends At

The Same Point On The Other Side

Metal Fireplace Wall

Bottom Screen

Hinge