User's Manual

www.malags.com
23
As seen a steady light on a LED indicates an interruption in the
optical communication. This means either a fibre optic cable
has failed or, the fibre optic connectors need to be cleaned
with the compressed air can provided with the system. When
none of the LED’s is blinking a power failure to the electronics
unit has occurred. Replace or recharge the battery. If the
electronics still do not function with a fresh battery then there is
an internal failure in the Shielded Electronics Unit.
To mount the shielded electronic on a shielded antenna,
perform as follows;
?? Place the Shielded Electronics Unit on the antenna with
facing the cable hose towards the antenna front.
NOTE: DO NOT TRY TO MOUNT THE ELECTRONICS IN
THE REVERSE DIRECTION. THIS WILL DAMAGE THE
ELECTRONIC UNIT.
?? See to that the unit is firmly attached to the antenna
before you fasten the two black mounting screws.
?? Mount a battery pack to the electronic unit.
?? When appropriate mount the survey wheel at the
antenna rear and connect the signal cable to the
electronics unit.
?? Attach the cable hose to the backpack as a strain relief.
?? Connect the optical fibers labeled T, D and R to the
CUII.
?? Connect the signal cable from the survey wheel to the
CUII.