User's Manual

8
2.6 Kill switch
The kill switch is attached to a
handle that can either be
handheld or snapped onto a
RAMAC/GPR Cart (Figure 2.6
top).
The X3M/EasyLocator will not
be operational without the kill
switch. The button has to be
pushed down at all times
during measurements. If the
button is released the
transmitter will stop
transmitting.
Connect the kill switch to the
bayonet holder on the X3M/EasyLocator
by pushing lightly and turning the bayonet
socket clockwise (Figure 2.6 bottom).
To disconnect: Turn the bayonet socket
counterclockwise and pull out.
2.7 Start up and power button
To start the X3M/EasyLocator press and hold the start button for
approximately two seconds. The light in the center of the button will start to
flash (Figure 2.7).
Next start the acquisition software,
GroundVision or EasyVision, in your
computer. During the measurement the
button will have a steady light.
The X3M/EasyLocator has autostacking as
a default setting. More information about
autostacking and how to operate the
software will be found in their respective
manuals
Figure 2.7. Power
Figure 2.6. Kill switch
Kill switch