User's Manual
www.malags.com
6
?? Make sure that the battery is fully charged for the
control unit CUII (See Operating Manual CUII) and
correctly mounted. This battery also supplies the 1.2
GHz antenna with power.
?? Connect the CUII supporting system part to the CUII
itself. Three short coaxial cables to the R, T and D
connectors and the encoder cable to the CUII encoder
connection. The T corresponds to transmitter, R to
receiver and D to data. See picture below.
?? Connect the CUII (LPT1) to the external PC parallel port
or to the parallel port on the RAMAC Monitor.
?? Connect the 1.2 GHz data cable to the control unit CUII
(dark gray connector at the left-hand side in the picture
above).
?? Attach an appropriate length-measuring device and
connect it to port ENC on the antenna. When using the
wheel carriage, the encoder is mounted on one of the
wheels and only need to be connected to the antenna.
?? Turn on the power on the CUII. Turn on the PC or the
RAMAC Monitor. Your RAMAC 1.2 GHz is now ready
for operation.