Installation Guide

17 / 41
Fig. 39
12
Grasp Snap in valve [1] with a plier and pull off from
Wheel [2].
6-7-2 Assembling
Fig. 33
1
Apply Bead cream [3] to insert surface of Snap in valve [1]
and a mounting hole [2] of Wheel all around.
2
Insert Snap in valve [1] into the hole [2] of Wheel by
picking up screw side of Valve [1] to pass through the hole.
3
Put Flat washer 8 [5] onto screw side of Snap in valve [1]
and then fasten Decorative valve cap [6] (commercial
product) by lifting up the Flat washer 8 with 1R263.
Tips
Don’t fasten Decorative valve cap [6] so tightly because
if it is fastened tightly 1R263 cannot be hooked under the
Washer.
Fig. 41
4
Apply Bead cream around the edge of the beads of Front
tire 430 [1] as shown in red dot of left Fig. Also apply Bead
cream to the Wheel-inserting side.
5
Also apply Bead cream around the periphery of bead seat
of the Wheel[2].
Tips
Apply Bead cream rather a lot to prevent from air leak
and lubrication for engagement.
[1]
[2]
[1]
[3]
[2]
1R263
[4]
[6]
[5]
Lid of Bead cream
Bead cream
[1]
[2]