Installation Guide

6 Wiring diagram
Fig. 6-1
Put the lead wires
(yellow, blue, orange)
of Power supply cord
into any of these Lead
wire holders.
Put Closed end splice for
Controller lead wire
(red) and lead wires of
Lead unit in the rib D.
Put each closed end splice
(2-SD) into the rib C.
Route the lead wires of Power
supply cord through Line filters
C (if used), and set the Line
filters in the position shown
below.
Put the lead wires
of Power supply
cord in this
groove.
Put each closed end splice into the rib B.
Put the lead wires into any
of these Lead wire holders.
Put the lead wires in this
Lead wire holder.
Put the lead wires into
any of these Lead wire
holders.
Do not put lead wires on the rib E and Lead unit.
Face the longer part of lead wires of Power supply
cord to Deck.
Route the lead wires
(yellow, blue,
orange) of Power
supply cord
between the rib A
and Lead unit.
Set the sheath of Power supply cord inside A as
shown below.
Route the lead wires of
Controller as shown in the
figure.
Rib B
Lead unit
Put the lead wires from
Terminal into this lead wire
holder.
Power supply cord
Strain relief
Strain relief
3mm
10mm
A
Rib A
Rib E
Rib C
Rib D
Controller
Deck
18 / 21