Instruction manual

7
Installing side grip (auxiliary handle) & cover
1
2
004419
1
2
004420
CAUTION:
• Always be sure that the side grip is installed
securely before operation.
Install the cover, then screw the side grip on the tool
securely. The side grip and the cover can be installed on
either side of the tool.
Installing or removing backing pad
1
2
3
004421
Hold the spindle with the wrench so that it cannot
revolve. Then screw the pad onto the spindle all the way.
(The pad can be used to install the optional sponge
pad.)
To remove the pad, follow the installation procedure in
reverse.
Installing or removing sponge pad
1
2
004422
To install the sponge pad, first remove all dirt or foreign
matter from the pad. Install the sponge pad to the pad.
To remove the pad, pull it off from the pad slowly.
Installing or removing the wool bonnet
1
2
3
004424
Mount the rubber pad onto the spindle. Screw the lock
nut onto the spindle.
To tighten the lock nut, hold the spindle with the wrench
so that it cannot revolve, then use the lock nut wrench
and securely tighten clockwise.
1
2
004425
Fit the wool bonnet completely over the rubber pad and
pull the string tight. Tie a bow knot and tuck the knot and
any loose strings between the wool bonnet and the
rubber pad.
1. Lock nut wrench
2. Wrench
1. Wool bonnet
2. Lock nut
3. Rubber pad
1. Sponge pad
2. Pad
1. Backing pad
2. Spindle
3. Wrench
1. Cover
2. Side grip
1. Cover
2. Side grip