Instruction manual

2
ENGLISH (Original instructions)
SPECIFICATIONS
Model PV7000C
Max capacities Sponge pad/ Wool bonnet 180 mm
Spindle thread M14
Rated speed (n)/No load speed (n
0
) 600 - 2,000 min
-1
Overall length 210 mm
Net weight 2.1 kg
Safety class /II
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
END202-6
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･ Read instruction manual.
･ DOUBLE INSULATION
･ Wear safety glasses.
･ Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic equipment and its
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an environmentally compatible
recycling facility.
ENE051-1
Intended use
The tool is intended for polishing, smoothing before
painting, finishing surfaces, and removing rust and paint.
ENF002-1
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
ENG102-3
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
pA
) : 81 dB(A)
Sound power level (L
WA
) : 92 dB(A)
Uncertainty (K) : 3 dB(A)
Wear ear protection
ENG240-1
Vibration
The vibration total value (tri-axial vector sum)
determined according to EN60745:
Work mode : polishing
Vibration emission (a
h,P
) : 2.5 m/s
2
or less
Uncertainty (K) : 1.5 m/s
2
If the tool is used for other applications, the vibration
emission value may be different.
ENG901-1
•
The declared vibration emission value has been
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
• The declared vibration emission value may also be
used in a preliminary assessment of exposure.
WARNING:
• The vibration emission during actual use of the
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
• Be sure to identify safety measures to protect the
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
ENH101-13
For European countries only
EC Declaration of Conformity
We Makita Corporation as the responsible
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
Electronic Polishe
r
Model No./ Type: PV7000C
are of series production and