User Manual

20
21
Installing and removing the dispersion cover
To install the dispersion cover (1), mount the dispersion cover on the top nozzle (2)
so that its protrusion (3) is aligned with the notch (4) in the top nozzle.
(2)
(4)
(1)
(3)
(2)
(3)
(4)
(1)
Secure the dispersion cover by turning it fully clockwise.
To remove the dispersion cover, follow the above procedure in reverse.
Changing the nozzle to a small-amount-solution-discharge
nozzle (optional accessory)
When a small amount of solution needs to be sprayed, replace the nozzle cap with
another type of supplied nozzle cap with a small discharge hole.
To replace the nozzle, follow the procedure below.
1. Remove the screw (1) from the second nozzle (2) and then remove the top nozzle
(3) and dispersion cover (4).
Installing and removing the deector (optional accessory)
The deector (1) allows chemicals to be sprayed upward. This helps treatment for
low-growing plants and the underside of leaves of plants.
To install the deector (1), mount the deector on the top nozzle so that the “I” mark
(3) on it is aligned with the “I” mark (4) of the top nozzle (2).
Secure the deector by turning it fully clockwise.
To remove the deector, follow the above procedure in reverse.
(1)
(2)
(3)
(4)
(1)