Use and Care Manual

9 ENGLISH

► 1. Lock nut 2. Convex section 3. Offset diamond

wheel 4. Inner ange 5. Spindle 6. Shaft lock

Connecting a vacuum cleaner

Optional accessory

When you wish to perform clean concrete-planing

operation, connect a Makita vacuum cleaner to your

tool. Then connect a hose of the vacuum cleaner to the

nozzle as shown in the gures.

Installing or removing dust cover

attachment

Optional accessory

WARNING: Always be sure that the tool is

switched off and unplugged before installing or

removing the dust cover attachment. Failure to do

so causes damage to the tool or a personal injury.

There are four pieces of dust cover attachment and

each is used in one of different positions.

► 1. Marking A 2. Marking B 3. Marking C

4. Marking D

Set the dust cover attachment so that the marking (A,

B, C or D) places as shown in the gure. Snap its pins

in the vents.

Dust cover attachment can be removed by hand.

NOTE: Clean out the dust cover attachment when it

is clogged with dust or foreign matters. Continuing

operation with a clogged dust cover attachment will

damage the tool.

OPERATION

Concrete planing operation

CAUTION: ALWAYS hold the tool rmly with

one hand on the housing and the other on the

auxiliary handle as shown in the gure.

CAUTION: Before operation, make sure that

a vacuum cleaner is connected to the tool and

turned on.

CAUTION: Do not use the tool with damaged

brush. Use of damaged brush could lead to injury by

leaking dust.

Always install the auxiliary handle on the tool before

operation. Hold the tool's switch handle and the auxil-

iary handle rmly with both hands during operation.