Use and Care Manual

8 ENGLISH
Installing or removing dust
collecting wheel guard
WARNING: Always switch OFF and unplug
the tool before attaching dust collecting wheel
guard.
WARNING: Dust collecting wheel guard is
only for use in planing concrete surface with
a offset diamond wheel. Do not use this guard
with any other cutting accessory or for any other
purpose.
WARNING: Inspect dust collecting wheel
guard thoroughly before use to ensure that it is
not damaged, cracked and/or deformed.
Remove any abrasive wheel and wheel cover from the
tool.
Loosen the screw on dust collecting wheel guard until
attaching slot opens.
1
2
► 1. Screw 2. Dust collecting wheel guard
Mount dust collecting wheel guard with the protrusion
on the dust collecting wheel guard aligned with the
notch on the bearing box.
1
2
3
4
► 1. Dust collecting wheel guard 2. Bearing box
3. Protrusion 4. Notch
Turn the dust collecting wheel guard in direction of the
arrow. Be sure to tighten the screw securely.
1
► 1. Screw
To remove the dust collecting wheel guard, follow the
above installing procedure in reverse.
Installing or removing offset
diamond wheel
Optional accessory
WARNING: For offset diamond wheels that
are 4 mm (5/32″) or thinner, place the convex
section of the lock nut upwards and attach to the
spindle.
WARNING: Be sure to use a genuine Makita
offset diamond wheel.
CAUTION: When installing a diamond wheel,
always make sure to tighten the lock nut rmly.
Mount the inner ange onto the spindle.
Make sure to t the dented part of the inner ange onto
the straight part at the bottom of the spindle.
Fit the offset diamond wheel on the inner ange and
screw the lock nut onto the spindle.
To tighten the lock nut, press the shaft lock rmly so
that the spindle cannot revolve, then use the lock nut
wrench and securely tighten clockwise.
To remove the wheel, follow the above installing proce-
dure in reverse.