ENGLISH (Original instructions) INSTRUCTION MANUAL Demolition Hammer HM1213C HM1203C 009939 DOUBLE INSULATION IMPORTANT: Read Before Using.
ENGLISH (Original instructions) SPECIFICATIONS Model HM1213C HM1203C 950 - 1,900 min-1 Blows per minute Overall length 576 mm Net weight 10.8 kg 9.7 kg Safety class II • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. • Note: Specifications may differ from country to country. • Weight according to EPTA-Procedure 01/2003 END201-5 Symbols Model HM1203C The following show the symbols used for the equipment.
ENH213-6 GEA005-3 For European countries only General Power Tool Safety Warnings EC Declaration of Conformity We Makita Corporation as the responsible manufacturer declare that the following Makita machine(s): Designation of Machine: Demolition Hammer Model No./ Type: HM1213C, HM1203C Specifications: see "SPECIFICATIONS" table.
dangerous in the hands of untrained users. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tool’s operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. 23. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. 24.
8. 9. 10. 11. 12. 13. 14. 15. warm-up, hammering operation is difficult. Always be sure you have a firm footing. Be sure no one is below when using the tool in high locations. Hold the tool firmly with both hands. Keep hands away from moving parts. Do not leave the tool running. Operate the tool only when hand-held. Do not point the tool at any one in the area when operating. The bit could fly out and injure someone seriously.
• CAUTION: The speed adjusting dial can be turned only as far as 5 and back to 1. Do not force it past 5 or 1, or the speed adjusting function may no longer work. ASSEMBLY • For Model HM1213C only CAUTION: Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Side handle (auxiliary handle) 1. Side handle 2.
OPERATION Chipping/Scaling/Demolition 009941 After installing, always make sure that the bit is securely held in place by trying to pull it out. To remove the bit, pull the releasing cover down all the way and pull the bit out. 009948 Always use the side grip (auxiliary handle) and firmly hold the tool by both side grip and switch handle during operations. Turn the tool on and apply slight pressure on the tool so that the tool will not bounce around, uncontrolled.
Disconnect the connector by pulling them. 3 1. Connector 2. White 3. Black 1. Connector 2. White 3. Black 3 1 1 2 Connect the connector firmly and then reinstall the handle. 009950 Loosen the four screws on crank cap and remove the crank cap cover. CAUTION: Be careful not to damage the connector or lead wires especially when installing the handle.
Makita Corporation Anjo, Aichi, Japan 884887C222 12 www.makita.
