Specifications

5
FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and unplugged before
adjusting or checking function on the tool.
Switch action
CAUTION:
• Before plugging in the tool, always check to see that the tool is switched
off.
To st ar t t he t oo l, pu sh t he sw it ch le ve r o n t h e l ef t s id e o f th e t oo l. To st op t he
tool, push the switch lever on the right side of the tool.
Speed change
For HM1100C only
The blows per minute can be adjusted just by turning the adjusting dial. This
can be done even while the tool is running. The dial is marked 1 (lowest
speed) to 5 (full speed).
Refer to the table below for the relationship between the number settings on
the adjusting dial and the blows per minute.
CAUTION:
• The speed adjusting dial can be turned only as far as 5 and back to 1. Do
not force it past 5 or 1, or the speed adjusting function may no longer
work.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and unplugged before
carrying out any work on the tool.
1. Switch lever
1
002888
1. Adjusting dial
1
002895
Number
on adjusting dial
5
4
3
2
1
Blows
per minute
2,650
2,350
1,950
1,550
1,300
002896