ENGLISH (Original instructions) INSTRUCTION MANUAL Demolition Hammer HM0871C HM0870C 010450 DOUBLE INSULATION IMPORTANT: Read Before Using.
ENGLISH (Original instructions) SPECIFICATIONS Model HM0871C HM0870C 1,100 - 2,650 min-1 Blows per minute Overall length 466 mm Net weight 5.6 kg Safety class 449 mm 5.1 kg II • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. • Specifications may differ from country to country.
ENG901-1 • • • GEA005-3 The declared vibration emission value has been measured in accordance with the standard test method and may be used for comparing one tool with another. The declared vibration emission value may also be used in a preliminary assessment of exposure. • General Power Tool Safety Warnings WARNING Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury.
dangerous in the hands of untrained users. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tool’s operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. 23. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. 24.
8. 9. 10. 11. 12. 13. 14. 15. warm-up, hammering operation is difficult. Always be sure you have a firm footing. Be sure no one is below when using the tool in high locations. Hold the tool firmly with both hands. Keep hands away from moving parts. Do not leave the tool running. Operate the tool only when hand-held. Do not point the tool at any one in the area when operating. The bit could fly out and injure someone seriously.
Indicator lamp For tool with D-shaped side handle 1. Power-ON indicator lamp (green) 2. Service indicator lamp (red) 1 1. D-sided side handle 2. Clamp nut 1 2 2 010456 010453 The green power-ON indicator lamp lights up when the tool is plugged. If the indicator lamp does not light up, the mains cord or the controller may be malfunction.
NOTE: • The change ring cannot turn when the bit is not installed on the tool. OPERATION Chipping/Scaling/Demolition 010490 After installing, always make sure that the bit is securely held in place by trying to pull it out. 1. Releasing cover 1 010495 010491 To remove the bit, pull the releasing cover down all the way and pull the bit out. Bit angle 010455 1. Change ring Always use the side grip (auxiliary handle) and firmly hold the tool by both side grip and switch handle during operations.
specified amount of grease. 1. Screws 1 CAUTION: Be careful not to damage the connector or lead wires especially when wiping out the old grease. To reassemble the tool, follow the disassembling procedure in reverse. • 010458 • Run the tool for several minutes to warm it up. Switch off and unplug the tool. Loosen the four screws and remove the handle. Note that the top screws are different from other screws. • CAUTION: Do not tighten the crank cap excessively.
Makita Corporation Anjo, Aichi, Japan 884928C224 www.makita.
