Use and Care Manual
9 ENGLISH
Disabling the quick mode-switching button
You can also disable the quick mode-switching button. After
disabling, the quick mode-switching button will not work for
changing the impact force and switching the application mode.
To disable the quick mode-switching button, press and
hold the quick mode-switching button and the but-
ton at the same time until the all lamps on the panel
blink.
To resume the quick mode-switching button, perform
the same procedure as above again.
NOTE: Registering and erasing the application mode
can be performed even if the quick mode-switching
button is disabled. After registering or erasing the
application mode, the quick mode-switching button
will be activated.
Quick reference
The following table shows the functions of the quick mode-switching button.
indicates the quick mode-switching button.
Button(s) / Purpose Action How to conrm
(When quick mode-switching function
is OFF)
Changing the impact force by the quick
mode-switching button
Press
The front lamps on the tool ash once.
(When quick mode-switching function
is ON)
Switching to the registered application
mode
Press
The front lamps on the tool ash once.
+
Registering the application mode
Press and hold (each button) Example: Wood mode is registered
The lamp of desired application mode
blinks.
+
Erasing the registered application mode
Press and hold (each button)
All impact force grade lamps blink.
+
Disabling/resuming the quick
mode-switching button
Press and hold (each button)
All lamps on the panel blink.
: The lamp is blinking.