Use and Care Manual

7 ENGLISH
ASSEMBLY
CAUTION: Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing 300 ml (10 
oz) size holder
Installing or removing the holder
joint
Attach the holder joint and plate by securing the screws
rmly. To remove the holder joint, follow the installation
procedure in reverse.
12 3
► 1. Screw 2. Plate 3. Holder joint
Installing or removing the rod and
piston
1. Insert the rod from the rear side of the tool with its
teeth facing down.
1
► 1. Short rod
2. Attach piston A with the screw.
12 3
► 1. Screw 2. Piston A 3. Short rod
NOTICE: Available type of caulking material con-
tainer for 300 ml (10  oz) size holder is cartridge
only. Be sure to attach piston A to the rod.
To remove the rod and piston, follow the installation
procedure in reverse.
Installing or removing the holder
CAUTION: Secure the holder to the holder
joint rmly. Otherwise the holder may come off
during operation and may cause an injury.
To install the holder, turn it clockwise rmly until it stops
while holding the holder joint. To remove the holder,
follow the installation procedure in reverse.
1
► 1. Holder
Installing or removing 600 ml (20 
oz) or 800 ml (29  oz) size holder
Installing or removing the holder
joint
Attach the holder joint and plate by securing the screws
rmly. To remove the holder joint, follow the installation
procedure in reverse.