Operation Manual

19
B
A
Adding grease and lubricant
Important: Make sure that the surface of gear box is completely cold before
lubricating.
- The gearbox of the pole hedge trimmer should be greased every 25 working
hours. The grease hole locates under the bolt. Remove the bolt to lubricate. Add

lubricant to the point B respectively via the grease hole. Return the bolt after


CAUTION: Observe greasing intervals and the amount of grease to be supplied.
Mechanical parts of the pole hedge trimmer may be damaged if grease

grease is added.
Daily inspection and maintenance
To ensure a long service life of your pole hedge trimmer, perform the following
inspections and maintenance on a daily basis.
- Before use;
 Always check for loose or missing parts before starting operation. Pay special
attention to the cutting unit and make sure that the cutting blade lock screws
are well tightened.
 
cylinder before starting operation. Clean if necessary.
- After use;
 Clean the pole hedge trimmer externally and inspect for damage.
 
dusty conditions.
 Check the cutting blades for damage. Make sure that the blades are securely
mounted.
 If the cutting blades still continue to run at idle after the adjustment, consult
your nearest authorized service agent.
Grease hole
(under the bolt)