Operation Manual
10
WARNING:
Make sure that the engine is turned off, and remove the spark plug cap before
assembling the pole hedge trimmer.
Wear protective gloves!
Secure cutting blades with the blade cover provided when connecting the trimmer
unit to the pole.
1. Remove the cap (1) from the shaft.
2. Loosen the M5 x 16 bolt (2) and M5 x 25 bolt (3).
NOTE: Make sure that the shaft is completely inserted into the cover
If you are having trouble inserting the shaft, manually rotate the drive axle
(6) a little and try again.
and the M5 x 25 bolt.
(2)
(1)
(4)
(6)
(5)
(3)
E N 4950H E N 4951S H
(1)
ASSEMBLY
to engine
Arrow mark
ATTACHING THE HANDLE (for EN4950H)
- Fix the loop handle on the shaft as shown.
- To keep a proper distance between the grips, set the loop handle ahead of the
arrows.
How to wear the shoulder strap
- Wear the shoulder strap over the left shoulder.
- Keep the pole hedge trimmer unit on the right hand side of the body.
- Attach the strap to the hanger provided on the pole hedge trimmer and adjust the
length of the strap to attain a comfortable working position.
Detachment
- In an emergency, push the notches (1) at both sides, and you can detach the
machine from you.
Be extremely careful to maintain control of the machine at this time. Do not allow
WARNING: Failure to maintain complete control of the machine at all could result in
serious bodily injury or DEATH.
SHOULDER STRAP (optional accessory)