ENGLISH INSTRUCTION MANUAL Cordless Driver Drill DF030D 008796 WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
ENGLISH SPECIFICATIONS Model Capacities -1 No load speed (min ) DF030D Steel 10 mm Wood 21 mm Wood screw 5.1 mm x 63 mm Machine screw M6 High (2) 0 - 1,300 Low (1) 0 - 350 Chuck capcity 6.35 mm Overall length 157 mm Net weight 0.88 kg Rated voltage D.C. 10.8 V • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. • Note: Specifications may differ from country to country.
13. Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to a rotating part of the power tool may result in personal injury. 14. Do not overreach. Keep proper footing and balance at all times. This enables better control of the power tool in unexpected situations. 15. Dress properly. Do not wear loose clothing or jewellery. Keep your hair, clothing, and gloves away from moving parts. Loose clothes, jewellery or long hair can be caught in moving parts. 16.
SAVE THESE INSTRUCTIONS. one type of battery pack may create a risk of fire when used with another battery pack. 25. Use power tools only with specifically designated battery packs. Use of any other battery packs may create a risk of injury and fire. 26. When battery pack is not in use, keep it away from other metal objects, like paper clips, coins, keys, nails, screws or other small metal objects, that can make a connection from one terminal to another.
Overcharging shortens the battery service life. Charge the battery cartridge with room temperature at 10 ﾟ C - 40 ﾟ C (50 ﾟ F - 104 ﾟ F). Let a hot battery cartridge cool down before charging it. 3. actuates properly and returns to the "OFF" position when released. To start the tool, simply pull the switch trigger. Tool speed is increased by increasing pressure on the switch trigger. Release the switch trigger to stop. Turning on the front lamp FUNCTIONAL DESCRIPTION • 1.
ASSEMBLY When not operating the tool, always set the reversing switch lever to the neutral position. • Speed change 1 CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. • 1. Speed change lever Installing or removing driver bit or socket bit 008803 To change the speed, first switch off the tool and then slide the speed change lever to the "2" side for high speed or "1" side for low speed.
Screwdriving operation 1. Bit 2. Sleeve 1 2 008799 008805 2. To install the bit, pull the sleeve in the direction of the arrow and insert the bit-piece and bit into the sleeve as far as it will go. The bit-piece should be inserted into the sleeve with its pointed end facing in. Then release the sleeve to secure the bit. CAUTION: Adjust the adjusting ring to the proper torque level for your work. Place the point of the driver bit in the screw head and apply pressure to the tool.
• • • • • Thread a waist belt or similar through holster holder. Put the tool in the holster and lock it with the holster button. CAUTION: Pressing excessively on the tool will not speed up the drilling. In fact, this excessive pressure will only serve to damage the tip of your bit, decrease the tool performance and shorten the service life of the tool. There is a tremendous force exerted on the tool/bit at the time of hole break through.
ACCESSORIES CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center.
Makita Corporation Anjo, Aichi, Japan 884796-225 12
