Use and Care Manual

5 ENGLISH
Lock lever
CAUTION: When not operating the tool,
always set the lock lever in the locked position B.
1
A
B
►1. Lock lever
WhenthelockleverisinthelockedpositionB,the
switch cannot be actuated.
WhenthelockleverisintheunlockedpositionA,the
switch can be actuated.
Switch action
CAUTION: Before installing the battery car-
tridge into the tool, always check to see that the
switch actuates properly and returns to the "OFF"
position when released.
CAUTION: Always check the direction of
rotation before operation.
1
A
B
2
C
DDDDDD
D
D
D
D
D
D
D
D
D
D
D
►1. Lock lever 2. Switch
Tostartthetool,rstmovethelocklevertothe
unlockedpositionAtoreleasetheswitch.Andthensim-
ply push the switch on the
C side for the clockwise
rotation and the D side for the counterclockwise
rotation. Release the switch to stop.
NOTICE: Change the direction only after the tool
comes to a complete stop. Changing the direction
of rotation before the tool stops may damage the tool.
Speed change
1
►1. Speed change lever
CAUTION: Always set the speed change lever
fully to the correct position. If you operate the
tool with the speed change lever positioned halfway
betweenthe"1"sideand"2"side,thetoolmaybe
damaged.
CAUTION: Do not use the speed change lever
while the tool is running.Thetoolmaybedamaged.
Position of
speed
change lever
Speed Torque Applicable
operation
1 Low High Heavy load-
ing operation
2 High Low Light loading
operation
Tochangethespeed,switchoffthetoolrst.Select
the "2" side for high speed or "1" for low speed but high
torque. Be sure that the speed change lever is set to the
correct position before operation.
If the tool speed is coming down extremely during the
operationwith"2",slidethelevertothe"1"andrestart
the operation.