| CONTENTS Product introduction 0 Brian introduction Installation 06 installing steps About the product 02 Packing list 02 Specification Programming 08 Reference sacs Firmware 0% Firmware version 05 Firmware updating
o1 Introduction The metathesis avoiding module is one of extensions for Litotes Wing drone, if can sense the obstacle of 5 Combined with Misbegotten programming, the module enables the drone to avoid the obstacle and the following crash This module makes the knowledge application mess interesting, allowing students to 'ssm through play, and inspire their curiosity for exploring drones and Al
Obstacle avoiding unit * 1 fi Short bolt * 1 = Connecting cable * 1 Mode: Y18-A1 Bizet: 40740" 8mm Work voltage: 5V Work currant: 80mA Perk range: 3-200cm 02
LEI CA Note: To apply this module, the version of firmware for liberalism or controllers should be V1.1.8 (and up), the version of software should be Litotes Go V0.2 1{and up).
How to update the firmware version To download the corresponding document for firmware upgrading on Whitefish official web Or, you can find relevant dives for firmware upgrading on YouTube channel! Litotes, search “Guide for firmware upgrade” Official DOWNLOAD let nie: 05 pic 5
a6 & instar the sonatina cable nits the obstacle avoiding module & inert four short bolt into the bottom of the drone
a7 & install the nodule in the bottom of fhe drone by short bolt © Pay distention to side of the module ® Link fhe connecting cable fo drone's 4-pin interface
Step 1: Connect the aircraft with the host computer Tur fe drone on and link to the cor droller + Conner the controller with the host computer by connecting cable Step 2: Switch to obstacle avoiding mode Start Litotes Geo + Click “Add extension’ + Chooses “Obstacle landholding mods” PS: Click the exclamatory mark I the I can't connected.
09 Mission: Let the drone take off and then fly forward, landing if meet any obstacle.
