User manual

Wunderbar v2 23-10-17
(a) WiFi SSID
(b) Security type (open network, WEP, WPA, WPA2)
(c) WiFi password
(d) ConradConnect login name
(e) Short token generated in step 1 on ConradConnect [link]
(f) Device name generated in step 1 on ConradConnect [link]
During onboarding you will also be asked to put all sensors into on-
boarding mode, by clicking on the button on sensor boards (10).
Figure 10
8. Depending on your WiFi network and internet connection onboarding
process might take a minute or two. Once Wunderbar successfully
publishes message to MQTT broker a following message will appear
in the console:
MQTT connected to mqtt.cdc.conradconnect.de:8883
From this point on your Wunderbar is fully configured and sending
data to ConradConnect.
Page 24 of 28