User manual

Wunderbar v2 23-10-17
4 Onboarding
4.1 Prerequisites
Wunderbar V2 firmware provides an onboarding method through USB.
Communication with Wunderbar is done over virtual com port, so a ter-
minal application is required. CoolTerm [link] is a free tool, recommended
on all operating systems and the following instruction will assume that this
app is used.
Note!
CoolTerm does not handle backspace key by default, so it is highly
recommended to enable this support in ‘Options’->’Terminal’ before
onboarding.
Figure 7: Option to enable proper backspace handling
4.2 Onboarding procedure
1. Create new Wunderbar device on ConradConnect [link], generate and
write down the short token and device name.
2. Connect Li-Ion Battery to Wunderbar board
Page 20 of 28