Manual

Smart Machine Smart Decision
SIM800 Series_AT Command Manual_V1.09 245 2015-08-03
0 Disable getting data from network manually, the module is
set to normal mode, data will be pushed to TE directly.
1 Enable getting data from network manually.
2 The module can get data, but the length of output data can
not exceed 1460 bytes at a time.
3 Similar to mode 2, but in HEX mode, which means the
module can get 730 bytes maximum at a time.
4 Query how many data are not read with a given ID.
<id> A numeric parameter which indicates the connection number
<reqlength> Requested number of data bytes (1-1460 bytes)to be read
<cnflength> Confirmed number of data bytes to be read, which may be less
than <length>. 0 indicates that no data can be read.
Parameter Saving
Mode
NO_SAVE
Max Response
Time
-
Reference Note
To enable this function, parameter <mode> must be set to 1 before
connection.
8.2.27 AT+CIPSCONT Save TCPIP Application Context
AT+CIPSCONT Save TCPIP Application Context
Read Command
AT+CIPSCONT
?
Response
TA returns TCPIP Application Context, which consists of the following
AT Command parameters.
+CIPSCONT: <mode0>
+CIPCSGP: <mode>
Gprs Config APN: <apn>
Gprs Config UserId: <user name>
Gprs Config Password: <password>
+CIPHEAD: <mode>
+CIPSHOWTP: <mode>
+CIPSRIP: <mode>
+CIPATS: <mode>,<time>
+CIPSPRT: <send prompt>,<notshowsendok>
+CIPQSEND: <n>
+CIPMODE: <mode>
+CIPCCFG:
<NmRetry>,<WaitTm>,<SendSz>,<esc>,<Rxmode>,<RxSize>,<Rxti
mer>
+CIPMUX: <n>