Manual

Smart Machine Smart Decision
SIM800 Series_AT Command Manual_V1.09 126 2015-08-03
+CBM: <length><CR><LF><pdu>
If <bm>=2 (text mode enabled):
+CBM: <sn>, <mid>, <dcs>, <page>, <pages><CR><LF><data>
3. Indicates that new SMS status report has been received
If <ds>=1 (PDU mode enabled):
+CDS: <length><CR><LF><pdu>
If <ds>=1 (text mode enabled):
+CDS: <fo>, <mr>[, <ra>][, <tora>], <scts>, <dt>, <st>
Parameter Saving
Mode
AT&W_SAV E
Max Response
Time
-
Reference
3GPP TS 27.005
Note
4.2.9 AT+CPMS Preferred SMS Message Storage
AT+CPMS Preferred SMS Message Storage
Response
+CPMS: (list of supported <mem1>s),(list of supported <mem2>s),(list of
supported <mem3>s)
OK
Test Command
AT+CPMS=?
Parameters
See Write Command
Response
+CPMS: <mem1>,<used1>,<total1>,<mem2>,<used2>,<total2>,
<mem3>,<used3>,<total3>
OK
ERROR
Read Command
AT+CPMS?
Parameters
See Write Command
Response
TA selects memory storages <mem1>, <mem2> and <mem3> to be used for
reading, writing, etc.
+CPMS: <used1>,<total1>,<used2>,<total2>,<used3>,<total3>
OK
ERROR
Write Command
AT+CPMS=<me
m1>[,<mem2>[,<
mem3>]]
Parameters
<mem1> Messages to be read and deleted from this memory storage