Specifications

REFERENCE
29
TROUBLESHOOTING
PRINTING PROBLEMS
PROBLEM SOLUTION
Can’t unload filament from
the MakerBot Replicator
Smart Extruder.
In the print monitor panel of MakerBot Desktop,
click Change, and then select Load Filament.
Let the filament extrude for a few seconds, then
click Done and Unload Filament to try
unloading again.
Can’t remove filament from
the MakerBot Replicator
Smart Extruder.
Make sure to wait to remove the filament until
MakerBot Desktop has instructed you to do
so. If you still cannot remove the filament, try
squeezing the tabs on the side of the Smart
Extruder and pulling on the filament.
Filament breaks between the
spool and the MakerBot Replicator
Smart Extruder.
Ensure that the filament unwinds counterclockwise
fromthespool.Alwaysunloadanylamentle
in the Smart Extruder before reloading. Make
sure the filament guide tube is secured to the
filament spool pocket.
Filament won’t extrude from
the Smart Extruder.
Try unloading and then reloading the filament.
Repeat this process a few times if necessary.
You may be able to avoid jams in the future by
allowing the Smart Extruder to cool to 50° C
before removing the Smart Extruder or turning
o your MakerBot Replicator Mini.