User manual

TROUBLESHOOTING
73
If your MakerBot Replicator 2X encounters problems during operation, the LCD menu will
display an error message. The following table describes each possible error message.
NOTE: If you see an error message in an unexpected context, submit a case to MakerBot
Support at www.makerbot.com/support/submit-a-case/
LCD ERROR MESSAGES
Error Message Description
Use the LCD menu to check your target
extruder temperatures. Navigate to Info
and Settings > Preheat Settings to make
sure the extruder temperatures are not
set higher than 300° C.
If the extruder temperatures are set to
below 300° C, visit makerbot.com/
support/new/support to learn what your
support options are.
To clear this message, you will have to
restart your MakerBot Replicator 2X.
Your MakerBot Replicator 2X has
automatically disabled its heaters aer a
period of inactivity as a safety precaution.
Restart your print or the preheat routine to
reset your heaters.