User guide

7TROUBLESHOOTING
REPLICATOR 2X SHAKES
Your Replicator 2X will shake during printing
if you print at high speeds with acceleration
turned o. Attempting to print at high
speeds with acceleration turned o can
harm your MakerBot Replicator 2X.
To check and change the Acceleration
setting, go to the LCD menu on your
Replicator MakerBot 2X and navigate to
Info and Settings > General Settings >
Accelerate. You can turn acceleration o and
on. You can also do this using the Onboard
Preferences in MakerWare or ReplicatorG.
Acceleration is turned on by default. If you
have acceleration turned o, you should not
print at speeds above 40 mm/s.
PRINTING ISSUES CONTINUED