User guide

If you are overextruding [Fig. 1.6], increase the
“feedstockMultiplier” setting by 0.05, save
the cong le, and Export your le again. If the
“feedstockMultiplier” setting reaches a value
of 1.0 without the problem being resolved, you
might have a dierent issue. Please contact
MakerBot Support.
If you are underextruding [Fig. 1.7], decrease
the “feedstockMultiplier” setting by 0.05,
save the cong le, and Export your le
again. Continue to decrease the value
entered for this setting in increments. If,
aer lowering the default setting by a total
of 0.2, your results do not improve, you
might have a dierent issue. Please contact
MakerBot Support.
DIAGNOSING PRINT QUALITY ISSUES CONTINUED
25TROUBLESHOOTING
File Name: 3D mouse Fig. 1.6
Design by: DDStarkey
Thingiverse: 61909
File Name: 3D mouse Fig. 1.7
Design by: DDStarkey
Thingiverse: 31909