User guide

MISALIGNED NOZZLES CONTINUED
15TROUBLESHOOTING
5. Look closely at your test print. First look at
the set of lines to the le (the lines that are
parallel to the front of the build plate). Notice
that the rst lines on the le are farther from
the front of the build plate than the first lines
on the right. Examine the lines and nd the
pair of lines that match best. The best match
will look the most like a single continuous line,
with both test lines perfectly centered. Note
the number. This is the best line for the Y axis.
6. Look at the set of lines to the right (the
lines that are perpendicular to the front of the
build plate). Examine the lines and nd the
pair that match best. The best match will look
the most like a single continuous line, with
both test lines perfectly centered. Note the
number. This is the best line for the X axis.
7. The LCD menu will prompt you to enter the
line number that is best for the X axis and the
line number that is best for the Y axis.
8. Use the arrow buttons to select a line
number and the M button to select a line
number. The MakerBot Replicator 2X will
store this information about the locations of
the extruder nozzles and use them to make
future prints align better.