Operation Manual

26
LOADING MAKERBOT FILAMENT CONTINUED
7
Stop Extrusion
Aer a few moments, you should see a thin
string of the MakerBot ABS Filament come
out of the right extruder nozzle. The filament
might curl and then straighten; this is normal.
Press the M button to stop extrusion.
NOTE: Don’t be surprised if the plastic that initially
comes out of the nozzle is not the color you
expected. This is filament le over from testing.
Wait until you see the color that you loaded come
out of the nozzle before you press the M button.
8
Reattach the Filament Guide Tube
Push the guide tube back into the opening
on the top of the right extruder.