Operation Manual

19SETUP
SETTING UP YOUR MAKERBOT REPLICATOR 2X CONTINUED
9
Attaching the Power Supply
10a. Locate the power supply and cable.
Attach the cable to the power supply.
10b. Ensure that the power switch on
the MakerBot Replicator 2X is set to
the OFF position.
10c. Insert the power supply connector into
the power input port on the back of the
MakerBot Replicator 2X. Ensure that the flat
side of the connector faces down.
NOTE: If at any time you need to unplug the
MakerBot Replicator 2X, pull on the connector itself
to release it from the power input port.
10
Powering On the MakerBot
Replicator 2X
11a. Plug the AC power cord into
an electrical outlet.
11b. Set the power switch to the
ON position.
11c. The MakerBot Replicator 2X will
display welcome text on the LCD panel. This
is the beginning of the startup script that
will guide you through initial
calibration and your first 3D print.
CAUTION: The socket-outlet must be
installed near the equipment and must
be easily accessible.