Operation Manual

ACCESSORY BOX CONTINUED
15SETUP
3
Removing the Accessory Box
3a. Remove the two remaining protective
foam pieces from the bottom of the
MakerBot Replicator 2X’s box.
3b. Li out the accessory box. This box
contains the remaining items from the
Accessory Box section.
4
Freeing the Extruders
4a. Use strong scissors or a wire cutter to
cut the zip ties holding the gantry system
in place. Discard the zip ties and the plastic
pieces holding them in place.
4b. A small plastic piece attached to the
X-axis belt and gantry rods prevents the
extruder from moving. Carefully snap the
piece o of the rods and tilt it to slide it
o of the belt.