Operation Manual

11
UNPACKING YOUR MAKERBOT REPLICATOR 2X
1
Opening the Box
1a. Place the MakerBot Replicator 2X box
on the ground. Open the box and remove the
top cardboard sheet.
1b. Remove the MakerBot Replicator 2X User
Manual. We recommend that you review
the manual to guide you through the setup
process and keep it handy as you unpack the
contents of the box. If you find that anything
described in the manual is missing, email us
at [e-mail].
1c. Remove the layer of foam and the sheet
of cardboard underneath.
1d. Remove the two protective foam pieces
from the sides of the MakerBot Replicator 2X.
2
Removing the MakerBot
Replicator 2X from the box
Open the plastic covering and firmly grasp
the frame of the MakerBot Replicator 2X.
Be careful not to grip the rods or belts of the
gantry system. Li it out of the box and place
it on a stable surface.
CAUTION: Do not force or tear anything
during unpackingand setup. This may
damage the MakerBot Replicator 2X.