Operation Manual

17
ATTACHING POWER SUPPLY AND POWERING ON
MOUNTING FILAMENT SPOOL AND ATTACHING USB CABLE
10a. Plug the AC power cord into an
electrical outlet.
10b. Set the power switch to the ON position.
10c. The MakerBot Replicator 2 will display
welcome text on the LCD panel. This is the
beginning of the startup script that will
guide you through initial calibration and
your first build.
10
Powering On the MakerBot Replicator 2
B SETTING UP YOUR MAKERBOT REPLICATOR 2 DESKTOP 3D PRINTER
CAUTION: Do not use an extension cord or power
supply other than the ones shipped with your MakerBot
Replicator 2. Ensure that the plug is easily accessible in
case the Replicator 2 needs to be disconnected.
MB2020_REP2_UserManual_V4.indd 17 7/22/13 5:32 PM