Operation Manual

13
UNPACKING YOUR MAKERBOT REPLICATOR 2 CONTINUED
3a. Remove the two remaining protective
foam pieces from the bottom of the
Replicator 2’s box.
3b. Li out the accessory box. This box
contains the remaining items from the
“What’s in the Box” section.
NOTE: Your MakerBot Replicator 2 should now be
fully unpacked. We recommend that you keep the
box and foam inserts in case you need to transport
your MakerBot Replicator 2 in the future.
2a. Open the plastic covering and firmly grasp
the frame of the MakerBot Replicator 2 from
the outside. Li it out of the box and place it
on a stable surface.
NOTE: The black cable is not a handle. Do not pull
or twist the black cable at any time.
3
Removing the Accessory Box 1
2
Removing the MakerBot Replicator 2 from the Box
B SETTING UP YOUR MAKERBOT REPLICATOR 2 DESKTOP 3D PRINTER
MB2020_REP2_UserManual_V4.indd 13 7/22/13 5:32 PM