Operation Manual

12
UNPACKING YOUR MAKERBOT REPLICATOR 2
1a. Place the MakerBot Replicator 2 box on
the ground. Open the box and remove the
top cardboard sheet.
1b. Remove the MakerBot Replicator 2 User
Manual. We recommend that you use the
manual to guide you through the setup
process and keep it at hand as you unpack
the contents of the box. If you find that
anything described in the manual is
missing, email us at [e-mail].
1c. Remove the layer of foam and the sheet
of cardboard underneath.
1d. Remove the two protective foam pieces
from the sides of the Replicator 2.
NOTE: You can download a PDF copy of this manual
at makerbot.com/support/replicator2.
1
Opening the Box 1
B SETTING UP YOUR MAKERBOT REPLICATOR 2 DESKTOP 3D PRINTER
MB2020_REP2_UserManual_V4.indd 12 7/22/13 5:32 PM