User manual
WELCOME, LET’S GET STARTED 5
Warning: The MakerBot Replicator+ 3D printer generates high temperatures. Always allow
the MakerBot Replicator+ Smart Extruder+ to cool down before you reach inside.
Warning: The MakerBot Replicator+ includes moving parts that can cause injury. Never
reach inside the MakerBot Replicator+ while it is in operation.
Warning: There is a risk of shock. The MakerBot Replicator+ is not user serviceable.
Caution: Do not leave the MakerBot Replicator+ unattended during operation.
Caution: Do not print using materials that have not been approved by MakerBot for use with
the MakerBot Replicator+.
Caution: The socket outlet must be located near the machine and must be easily accessible.
Caution: In case of emergency, disconnect the MakerBot Replicator+ from the socket outlet.
Caution: The MakerBot Replicator+ melts plastic during printing. Plastic odors may be
emitted during this operation. Make sure to set up the MakerBot Replicator+ in a well-
ventilated area.
Caution: Never remove the Smart Extruder+ from your MakerBot Replicator+ or turn o the
MakerBot Replicator+ during or immediately aer printing. Always allow the Smart Extruder
to cool completely before removing it from the MakerBot Replicator+ or turning o your 3D
printer.
Caution: Do not look directly at any operating LED component.
Caution: Children under 12 should be supervised by an adult.
Caution: Dust generation and accumulation should be minimized. Some dust and dry
powders can build static electricity charges when subjected to friction and create an ignition
hazard.
Safety alert symbols precede each safety message in this manual.
These symbols indicate potential safety hazards that could harm
you or others or cause product or property damage.