User manual

THE CONTROL PANEL 22
PRINT
SELECT A FILE
Select Print with the dial to initiate a print stored on
a USB flash drive or on the internal storage of the
MakerBot Replicator+.
Turn the dial to scroll through the list of available
locations. Push the dial to select the location of the file
you want to print.
Select USB Storage to print a file stored on a USB
drive inserted into the USB port.
Select Internal Storage to print a file stored on the
MakerBot Replicator+. The internal
storage has a capacity of 2 GB.
Press the dial to select a location. Turn the dial to
scroll through the list of available files and press it
again to select one.
START PRINT
If you select a file from a USB drive or internal storage,
the control panel will display the File screen. Files from a
USB drive must be in .makerbot format in order to print.
From the File screen, you can begin your print, gain more
information about the print, copy files, or delete files.
Select Print to start printing the file.
Select Info for more information on the print. Turn the
dial to toggle between the three screens which contain
a rendering of your model and more information about
your print.
Select Copy to copy a file to internal storage or to an
attached USB drive.
Select Delete to delete a file from internal storage or
from an attached USB drive.