User manual
GETTING STARTED 11
INSTALL THE SMART EXTRUDER+
1. Go to the MakerBot Replicator+ control panel and select Extruder > Attach Smart Extruder Now.
2. When directed, press the Smart Extruder+ against the back of the extruder carriage, with the connector
pins facing the carriage. Magnets will lock the Smart Extruder+ into place.
Caution: Never remove the Smart Extruder+ from your MakerBot Replicator+ during or immediately
aer printing. Always allow the Smart Extruder+ to cool completely for five to ten minutes before
removing it from the MakerBot Replicator+ 3D printer.
SETTING UP THE REPLICATOR+